Dell PowerConnect 6224 - Page 1248

1248 SNMP Commands
Syntax
snmp-server enable traps [ acl | all | authentication | captive portal |
dvmrp | link | multiple users | ospf
ospftype | ospfv3 ospfv3type | pim |
spanning tree ]
• ospftype - {
all |
errors { all | authentication failure | bad packet | config error | virt
authentication failure | virt bad packet | virt config error } | lsa { all
| lsa-maxage | lsa-originate } | overflow { all| lsdb-overflow | lsdb-
approaching-overflow } | retransmit {all |packets| virt-packets } |
state-change { all | if state change | neighbor state change | virtif
state change | virtneighbor state change }
}
•
ospfv3type - {
all |
errors { all | bad packet | config error | virt bad packet | virt config
error } | lsa { all | lsa-maxage | lsa-originate } | overflow { all| lsdb-
overflow | lsdb-approaching-overflow } | retransmit {all |packets|
virt-packets } | state-change { all | if state change | neighbor state
change | virtif state change | virtneighbor state change }
}
Default Configuration
Authentication, Link Up/Down, Multiple Users and Spanning Tree flags are
enabled by default.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.