738 IP Routing Commands
IcmpOutSrcQuenchs.............................. 0
IcmpOutRedirects............................... 0
IcmpOutEchoReps................................ 3
IcmpOutTimestamps.............................. 0
IcmpOutTimestampReps........................... 0
IcmpOutAddrMasks............................... 0
vlan routing
Use this command to enable routing on a VLAN. Use the “no” form of this
command to disable routing on a VLAN.
Syntax
vlan routing vlanid [ index ]
no vlan routing vlanid
vlanid — Valid VLAN ID (Range 1 – 4093).
index — Internal interface ID. This parameter is for NSF use only.
Default Configuration
Routing is not enabled on any VLANs by default.
Command Mode
VLAN Database mode
User Guidelines
The user is not required to use this command. Routing can still be enabled
using the routing command in VLAN Interface Configuration mode.
Example
console(config-vlan)# vlan routing 10 1
To Next Page
Loading...
