Command Groups 81
Radius
Command Description Mode*
aaa accounting network
default start-stop group
radius
Enables RADIUS accounting on the switch. GC
auth-port
Sets the port number for authentication
requests of the designated radius server
.
R
deadtime Improves Radius response times when a server is
unavailable by causing the unavailable server to
be skipped.
R
key
Sets the authentication and encryption key
for all RADIUS communications between
the switch and the RADIUS daemon
.
R
msgauth Enables the message authenticator attribute to
be used for the RADIUS Authenticating server
being configured.
R
name Assigns a name to a RADIUS server. R
primary Specifies that a configured server should be the
primary server in the group of authentication
servers which have the same server name.
R
priority Specifies the order in which the servers are to be
used, with 0 being the highest priority.
R
radius-server deadtime Improves RADIUS response times when servers
are unavailable. Causes the unavailable servers
to be skipped.
GC
radius-server host Specifies a RADIUS server host. GC
radius-server key Sets the authentication and encryption key for
all RADIUS communications between the
switch and the RADIUS daemon.
GC
radius-server retransmit Specifies the number of times the software
searches the list of RADIUS server hosts.
GC
radius-server source-ip Specifies the source IP address used for
communication with RADIUS servers.
GC
To Next Page
Loading...
