Dell PowerConnect 6224 - Ip Pimsm Dr-Priority; Ip Pimsm Hello-Interval; Ip Pimsm Join-Prune-Interval; Ip Pimsm Rp-Address

Command Groups 101
Multicast
Command Description Mode*
ip mcast boundary Adds an administrative scope multicast
boundary.
IC
ip mroute Creates a static multicast route for a source
range.
GC
ip multicast Sets the administrative mode of the IP
multicast forwarder in the router to active.
GC
ip multicast ttl-threshold Applies a
ttlvalue to a routing interface. IC
ip pimsm Administratively enables PIM-SM multicast
routing mode on a particular router interface.
IC
ip pimsm bsr-border Prevents bootstrap router (BSR) messages from
being sent or received through an interface.
IC
ip pimsm bsr-candidate Configures the router to announce its
candidacy as a bootstrap router (BSR).
GC
ip pimsm dr-priority Sets the priority value for which a router is
elected as the designated router (DR).
IC
ip pimsm hello-interval Configures the PIM-SM Hello Interval for the
specified interface.
IC
ip pimsm join-prune-
interval
Configures the interface join/prune interval for
the PIM-SM router.
IC
ip pimsm register-threshold Configures the Register Threshold rate for the
RP router to switch to the shortest path.
GC
ip pimsm rp-address Statically configures the RP address for one or
more multicast groups.
GC
ip pimsm rp-candidate Configures the router to advertise itself as a
PIM candidate rendezvous point (RP) to the
bootstrap router (BSR).
IC
ip pimsm spt-threshold Configures the Data Threshold rate for the
lasthop router to switch to the shortest path.
GC
ip pimsm ssm Defines the Source Specific Multicast (SSM)
range of IP multicast addresses.
GC