System Management Commands 1293
asset-tag
Use the asset-tag command in Global Configuration mode to specify the
switch asset tag. To remove the existing asset tag, use the no form of the
command.
Syntax
asset-tag
[unit] tag
no asset-tag
[unit]
•
unit
— Switch number. (Range: 1–12)
•
tag
— The switch asset tag.
Default Configuration
No asset tag is defined by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies the switch asset tag as 1qwepot. Because the
unit parameter is not specified, the command defaults to the master switch
number.
console(config)# asset-tag 1qwepot
banner motd
Use the banner motd command to control (enable or disable) the display of
message-of-the-day banners. banner motd enables the banner, and allows
configuration of message-of-the-day banners. Use no banner motd to delete
the message, and disable the banner.
To Next Page
Loading...
