494 QoS Commands
4 0 Weighted Tail
Drop
5 0 Weighted Tail
Drop
6 0 Weighted Tail
Drop
The following table lists the parameters in the examples and gives a
description of each.
show policy-map
Use the show policy-map command in Privileged EXEC mode to display all
configuration information for the specified policy.
Parameter Description
Interface The port of the interface. If displaying the global
configuration, this output line is replaced with a
global configuration indication.
Intf Shaping Rate The maximum transmission bandwidth limit for
the interface as a whole. It is independent of any
per-queue maximum bandwidth values in effect
for the interface. This value is a configured value.
Queue Mgmt Type The queue depth management technique used for
all queues on this interface.
Queue An interface supports
n
queues numbered 0 to
(
n
-1).The specific
n
value is platform-dependent.
Internal egress queue of the interface; queues 0–6
are available.
Minimum Bandwidth The minimum transmission bandwidth guarantee
for the queue, expressed as a percentage. A value of
0 means bandwidth is not guaranteed and the
queue operates using best-effort. This value is a
configured value.
Scheduler Type Indicates whether this queue is scheduled for
transmission using a strict priority or a weighted
scheme. This value is a configured value.
To Next Page
Loading...
