362 IP Addressing Commands
console(config)#ipv6 address autoconfig
console(config)#ipv6 address 2003::6/64
console(config)#ipv6 address 2001::/64 eui64
console(config)#no ipv6 address dhcp
console(config)#no ipv6 address autoconfig
console(config)#no ipv6 address 2003::6/64
console(config)#no ipv6 address 2001::/64 eui64
console(config)#no ipv6 address
ipv6 enable
Use the ipv6 enable command to enable IPv6 on the management interface.
Use the "no" form of this command to disable IPv6 on the management
interface.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
IPv6 is enabled on the management interface by default.
To Next Page
Loading...
