Dell PowerConnect 6224 - Ipv6 Router Ospf; Maximum-Paths

960 OSPFv3 Commands
console(config-if-vlan15)#ipv6 ospf transmit-delay
100
ipv6 router ospf
Use the ipv6 router ospf command in Global Configuration mode to enter
Router OSPFv3 Configuration mode.
Syntax
ipv6 router ospf
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
Use the following command to enable OSPFv3.
console(config)#ipv6 router ospf
maximum-paths
Use the maximum-paths command in Router OSPFv3 Configuration mode
to set the number of paths that OSPF can report for a given destination.
Syntax
maximum-paths maxpaths
no maximum-paths
• maxpaths — Number of paths that can be reported. (Range: 1-2)