OSPFv3 Commands 961
Default Configuration
2 is the default value for
maxpaths
.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the number of paths that OSPF can report for a
destination to 1.
console(config)#ipv6 router ospf
console(config-rtr)#maximum-paths 1
nsf
Use this command to enable OSPF graceful restart. Use the “no” form of this
command to disable graceful restart.
Syntax
nsf [ ietf ] [ planned-only ]
no nsf [ietf]
ietf — This keyword is used to distinguish the IETF standard
implementation of graceful restart from other implementations. Since the
IETF implementation is the only one supported, this keyword is optional.
planned-only — This keyword indicates that OSPF should only perform a
graceful restart when the restart is planned (i.e., when the restart is a result of
the initiate failover command).
Default Configuration
Graceful restart is disabled by default
To Next Page
Loading...
