Dell PowerConnect 6224 - Ipv6 Ospf Priority

OSPFv3 Commands 957
Syntax
ipv6 ospf network { broadcast | point-to-point }
no ipv6 ospf network
• broadcast — The network type is broadcast.
•
point-to-point — The network type is point-to-point.
Default Configuration
Broadcast is the default state.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example changes the default OSPF network type to point-to-
point.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf network point-to-
point
ipv6 ospf priority
Use the ipv6 ospf priority command in Interface Configuration mode to set
the OSPF priority for the specified router interface.
Syntax
ipv6 ospf priority priority
no ipv6 ospf priority
• priority — OSPF priority for specified interface. (Range: 0-255. A value of
0 indicates that the router is not eligible to become the designated router
on this network)