Dell PowerConnect 6224 - Cut-Through Mode

1296 System Management Commands
Command Mode
Privileged EXEC mode
User Guidelines
When nonstop forwarding is enabled on a stack, the stack's management unit
checkpoints operational data to the backup unit. If the backup unit takes over
as the management unit, the control plane on the new management unit uses
the checkpointed data when initializing its state. Checkpoint statistics track
the amount of data checkpointed from the management unit to the backup
unit.
Example
console#clear checkpoint statistics
cut-through mode
Use the cut-through mode command to enable the cut-through mode on the
switch. The mode takes effect on all ports on next reload of the switch. To
disable the cut-through mode on the switch, use the no form of this
command.
Syntax
cut-through mode
no cut-through mode
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
User Guidelines
No specific guidelines.