Dell PowerConnect 6224 - Ip Pimsm Spt-Threshold

998 PIM-SM Commands
ip pimsm
Use the ip pimsm command in Global Configuration mode to set
administrative mode of PIM-SM multicast routing across the router to
enabled. IGMP must be enabled before PIM-SM can be enabled.
Syntax
ip pimsm
no ip pimsm
Default Configuration
PIM-SM is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables PIM-SM on the router.
console(config)#ip pimsm
ip pimsm spt-threshold
Use the ip pimsm spt-threshold command in Global Configuration mode to
configure the Data Threshold rate for the last-hop (or leaf) router to switch to
the shortest path. The rate is specified in kilobits per second.
Syntax
ip pimsm spt-threshold threshold
no ip pimsm spt-threshold
• threshold — Threshold rate. (Range: 0-2000 kilobits/sec)