100 Command Groups
Loopback Interface
show ipv6 pimdm Displays PIM-DM Global Configuration
parameters and PIM DM interface status.
PE
show ipv6 pimdm neighbor Displays PIM-DM Neighbor information
including Neighbor Address, Uptime and
Expiry time for all interfaces or for the specified
interface.
PE
show ipv6 pimdm interface Displays PIM-DM Configuration information
for all interfaces or for the specified interface.
PE
show ipv6 neighbors Displays information about the IPv6 neighbors. PE
show ipv6 route Displays the IPv6 routing table. PE
show ipv6 route preference Shows the preference value associated with the
type of route.
PE
show ipv6 route summary Displays a summary of the routing table. PE
show ipv6 traffic Shows traffic and statistics for IPv6 and
ICMPv6.
UE
show ipv6 vlan Displays IPv6 VLAN routing interface
addresses.
PE
traceroute ipv6 Discovers the routes that packets actually take
when traveling to their destination through the
network on a hop-by-hop basis.
PE
NOTE: *For the meaning of each Mode abbreviation, see "Mode Types" on page 60.
Command Description Mode*
interface loopback Enters the Interface Loopback configuration
mode.
GC
show interface loopback Displays information about configured
loopback interfaces.
PE
NOTE: *For the meaning of each Mode abbreviation, see "Mode Types" on page 60.
Command Description Mode*
To Next Page
Loading...
