PIM-SM Commands 999
Default Configuration
50 kilobits/sec is the default rate.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a threshold rate of 100 kilobits/sec.
console(config)#ip pimsm spt-threshold 100
ip pim-trapflags
Use the ip pim-trapflags command in Global Configuration mode to enable
the PIM trap mode for both Sparse Mode (SM) and Dense Mode (DM).
Syntax
ip pim-trapflags
no ip pim-trapflags
Default Configuration
Disabled is the default state.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables PIM trap mode.
console(config)#ip pim-trapflags
To Next Page
Loading...
