Ethernet Configuration Commands 291
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The value set allows an additional four bytes for the VLAN tag.
Example
The following example of the mtu command increases maximum packet size
to 9216 bytes.
console(config-if-1/g5)#mtu 9216
negotiation
Use the negotiation command in Interface Configuration mode to enable
auto-negotiation operation for the speed and duplex parameters of a given
interface. To disable negotiation, use the no form of this command.
Syntax
negotiation [capability1 [capability2…capability5]]
no negotiation
•
capabilities —
Specifies capabilities to advertise. (Possible values: 10h,
10f, 100h,
100f, and 1000f)
Default Configuration
If unspecified, defaults to list of all capabilities of the port.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Entering the command negotiation with no parameters enables all
capabilities. Note that if you have previously entered negotiation with
capabilities, this action overwrites the previous configuration so that all
capabilities are enabled.
To Next Page
Loading...
