Dell PowerConnect 6224 - Show Fiber-Ports Optical-Transceiver

1166 PHY Diagnostics Commands
show fiber-ports optical-transceiver
Use the show fiber-ports optical-transceiver command in Privileged EXEC
mode to display the optical transceiver diagnostics.
Syntax
show fiber-ports optical-transceiver [ interface ]
• interface — A valid Ethernet port. The full syntax is unit / port.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
The show fiber ports command is only applicable to the SFP combo ports and
XFP ports (not the ports on the SFP+ plug-in module).
Examples
The following examples display the optical transceiver diagnostics.
console#show fiber-ports optical-transceiver
Port Temp Voltage Current Output Input
TX LOS
Power Power
Fault
----------- ------ ------- ------- ------ -----
----- ---
1/g3 w OK E OK OK
OK OK
1/g4 OK OK OK OK OK
E OK
1/g1 Copper