Dell PowerConnect 6224 - Snmp-Server Community

1244 SNMP Commands
overflow: lsdb-
overflow....................Enabled
lsdb-approaching-overflow........Enabled
retransmit:
packets..........................Disabled
virt-
packets.....................Disabled
rtb: rtb-entry-
info...................Disabled
state-change:
all..............................Disabled
if state change..................Enabled
neighbor state change............Enabled
virtif state change..............Disabled
virtneighbor state change........Disabled
snmp-server community
Use the snmp-server community command in Global Configuration mode to
set up the community access string to permit access to the SNMP protocol.
To remove the specified community string, use the no form of this command.
This Command places the user in SNMP-Community-Configuration mode.
Syntax
snmp-server community community - string {ro | rw | su} [ipaddress
ipaddress ] [view viewname ]
no snmp-server community
community-string
• community-string — Permits access to the SNMP protocol. (Range: 1-20
characters)
•
ro — Indicates read-only access
•
rw — Indicates read-write access.
•
su — Indicates SNMP administrator access.