830 Multicast Commands
Syntax
ip mroute
source-address source-mask rpf-address preference
no ip mroute
source-address source
•
source-address
— The IP address of the multicast data source.
•
source-mask
— The IP subnet mask of the multicast data source.
•
rpf-address
— The IP address of the next hop towards the source.
•
preference
— The cost of the route (Range: 1 - 255).
Default Configuration
There is no default configuration for this command.
Command Mode
Global Configuration mode
Usage Guidelines
There are no user guidelines for this command.
Example
console(config)#
console(config)#ip mroute 1.1.1.1 255.255.0.0
192.168.20.1 34
ip multicast
Use the ip multicast command in Global Configuration mode to set the
administrative mode of the IP multicast forwarder in the router to active. For
multicast routing to become operational, IGMP must be currently enabled.
An error message is displayed on the CLI if multicast routing is enabled while
IGMP is disabled. However, the IP multicast mode configuration is stored in
the multicast configuration file and is automatically enabled once IGMP is
enabled.
Syntax
ip multicast
To Next Page
Loading...
