288 Ethernet Configuration Commands
User Guidelines
This command has no user guidelines.
Example
The following example configures the duplex operation of Ethernet port 5 to
force full duplex operation.
console(config)# interface ethernet 1/g5
console(config-if-1/g5)# duplex full
flowcontrol
Use the flowcontrol command in Global Configuration mode to configure
the flow control. To disable flow control, use the no form of this command.
Syntax
flowcontrol
no flowcontrol
Default Configuration
Flow Control is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
In the following example, flow control is enabled.
console(config)# flowcontrol
To Next Page
Loading...
