832 Multicast Commands
User Guidelines
This command has no user guidelines.
Example
The following example applies a
ttlvalue
of 5
to the VLAN 15 routing
interface.
console(config)#interface vlan 15
console(config-if-vlan15)#ip multicast ttl-threshold
5
ip pimsm
The ip pimsm command is used to administratively enable PIM-SM
multicast routing mode on a particular router interface. Use the “no” form of
this command to disable PIM SM on an interface. This command deprecates
the ip pimsm mode command.
Syntax
ip pimsm
no ip pimsm
Default Configuration
PIM-SM is disabled by default.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ip pimsm
To Next Page
Loading...
