1242 SNMP Commands
show trapflags
Use the show trapflags command to show the status of the configurable
SNMP traps.
Syntax
show trapflags [ ospf | ospfv3 ]
ospf | ospfv3—Use this parameter to show detailed OSPF trap status
information
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
console#show trapflags
Authentication Flag............................
Enable
Link Up/Down Flag..............................
Enable
Multiple Users Flag............................
Enable
Spanning Tree Flag.............................
Enable
ACL Traps......................................
Disable
To Next Page
Loading...
