Dell PowerConnect 6224 - Show Interfaces Cos-Queue

QoS Commands 491
Syntax
show diffserv service brief
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to display all interfaces in the system to
which a DiffServ policy has been attached.
console# show diffserv service brief
Interface Direction OperStatus Policy Name
----------- ----------- ------------ ---------------
----
1/g1 in Down DELL
show interfaces cos-queue
Use the show interfaces cos-queue command in Privileged EXEC mode to
display the class-of-service queue configuration for the specified interface.
Syntax
show interfaces cos-queue [< unit>/<port-type><port> |port-channel
port-channel number ]
• <unit>/<port-type><port> — Specifies a valid unit/port combination:
–<
unit > — Physical switch identifier within the stack. Values are 1-12 .
–<
port-type > — Values are g for gigabit Ethernet port, or xg for 10
gigabit Ethernet port.