88 Command Groups
dot1x max-req Sets the maximum number of times the switch
sends an EAP-request frame to the client before
restarting the authentication process.
IC
dot1x max-users Sets the maximum number of clients supported
on the port when MAC-based 802.1X
authentication is enabled on the port.
IC
dot1x port-control Enables manual control of the authorization
state of the port.
IC
dot1x re-authenticate Manually initiates a re-authentication of all
802.1x-enabled ports or a specified 802.1X
enabled port.
PE
dot1x re-authentication Enables periodic re-authentication of the client. IC
dot1x system-auth-control Enables 802.1X globally. GC
dot1x timeout quiet-period Sets the number of seconds the switch remains
in the quiet state following a failed
authentication attempt
IC
dot1x timeout re-
authperiod
Sets the number of seconds between re-
authentication attempts.
IC
dot1x timeout server-
timeout
Sets the number of seconds the switch waits for
a response from the authentication server
before resending the request.
IC
dot1x timeout supp-
timeout
Sets the number of seconds the switch waits for
a response to an EAP-request frame from the
client before retransmitting the request.
IC
dot1x timeout tx-period Sets the number of seconds the switch waits for
a response to an EAP-request/identify frame
from the client before resending the request.
IC
show dot1x Displays 802.1X status for the switch or the
specified interface.
PE
show dot1x clients Displays detailed information about the users
who have successfully authenticated on the
system or on a specified port.
PE
show dot1x ethernet Shows the status of MAC Authentication
Bypass.
PE
Command Description Mode*
To Next Page
Loading...
