968 OSPFv3 Commands
Example
The following example sets a 4-digit dotted-decimal number identifying the
Router OSPF ID as 2.3.4.5.
console(config)#ipv6 router ospf
console(config-rtr)#router-id 2.3.4.5
show ipv6 ospf
Use the show ipv6 ospf command in Privileged EXEC mode to display
information relevant to the OSPF router.
Syntax
show ipv6 ospf
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
Some of the information below displays only if you enable OSPF and
configure certain features. The following fields may be displayed:
Router ID A 32-bit integer in dotted decimal format identifying the router
about which information is displayed. This is a configured value.
OSPF Admin
Mode
Shows whether OSPF is administratively enabled or disabled.
External LSDB
Limit
Shows the maximum number of non-default external LSAs
entries that can be stored in the link-state database.
Exit Overflow
Interval
Shows the number of seconds that, after entering
OverflowState, as defined by RFC 1765, a router will attempt to
leave OverflowState.
To Next Page
Loading...
