Dell PowerConnect 6224 - Distribute-List out

878 OSPF Commands
Examples
The following examples set route preference values of OSPF in the router.
console(config-router)#distance ospf intra 4
console(config-router)#distance ospf type1 19
distribute-list out
Use the distribute-list out command in Router OSPF Configuration mode to
specify the access list to filter routes received from the source protocol. Use
the no form of the command to remove the specified source protocol from
the access list.
Syntax
distribute-list accesslistname out {rip|static \ connected}
no distribute-list
accesslistname out {rip|static \ connected}
• accesslistname — The name used to identify an existing ACL. The range is
1–31 characters.
•
rip — Apply the specified access list when RIP is the source protocol.
•
static — Apply the specified access list when packets come through the
static route.
•
connected — Apply the specified access list when packets come from a
directly connected route.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.