Dell PowerConnect 6224 - Ip Arp Inspection Vlan; Permit Ip Host Mac Host; Show Arp Access-List; Show Ip Arp Inspection Ethernet

Command Groups 67
Ethernet Configuration
ip arp inspection vlan Enables Dynamic ARP Inspection on a single
VLAN or a range of VLANs.
GC
permit ip host mac host Configures a rule for a valid IP address and
MAC address combination used in ARP packet
validation.
ARPA
show arp access-list Displays the configured ARP ACLs with the
rules.
PE
show ip arp inspection
ethernet
Displays the Dynamic ARP Inspection
configuration on all the DAI enabled interfaces.
PE
show ip arp inspection
statistics
Displays the statistics of the ARP packets
processed by Dynamic ARP Inspection.
PE
show ip arp inspection vlan Displays the Dynamic ARP Inspection
configuration on all the VLANs in the given
VLAN range.
PE
NOTE: *For the meaning of each Mode abbreviation, see "Mode Types" on page 60.
Command Description Mode*
clear counters Clears statistics on an interface. PE
description Adds a description to an interface. IC
duplex Configures the full/half duplex operation of a
given Ethernet interface when not using auto-
negotiation.
IC
flowcontrol Configures the flow control on a given interface. GC
interface ethernet Enters the interface configuration mode to
configure an Ethernet type interface.
GC
interface range ethernet Enters the interface configuration mode to
configure multiple Ethernet type interfaces.
GC
mtu Enables jumbo frames on an interface by
adjusting the maximum size of a packet or
maximum transmission unit (MTU).
IC
Command Description Mode*