Dell PowerConnect 6224 - Show Switchport Protected

588 VLAN Commands
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the Protocol-Based VLAN information for
either the entire system.
console#show port protocol all
Group
Group
Name ID Protocol(s VLAN Interface(s)
--------------- ----- ---------- ---- -----------
-------------
test 1 IP 1 1/g1
show switchport protected
Use the show switchport protected command in Privileged EXEC mode to
display the status of all the interfaces, including protected and unprotected
interfaces.
Syntax
show switchport protected groupid
• groupid — Identifies which group the port is to be protected in. (Range: 0-
2)
Default Configuration
This command has no default configuration.