770 IPv6 Routing Commands
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables IPv6 routing, which has not been configured
with an explicit IPv6 address.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 enable
ipv6 forwarding
Use the ipv6 forwarding command in Global Configuration mode to enable
IPv6 forwarding on a router.
Syntax
ipv6 forwarding
no ipv6 forwarding
Default Configuration
Enabled is the default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
To Next Page
Loading...
