Dell PowerConnect 6224 - Isdp Holdtime

240 CDP Interoperability Commands
Default Configuration
ISDP is enabled.
Command Mode
Global Configuration mode.
Interface (Ethernet) configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example enables isdp on interface 1/g1.
console(config)#interface ethernet 1/g1
console(config-if-1/g1)#isdp enable
isdp holdtime
The isdp holdtime command configures the hold time for ISDP packets that
the switch transmits. The hold time specifies how long a receiving device
should store information sent in the ISDP packet before discarding it. The
range is given in seconds. Use the “no” form of this command to reset the
holdtime to the default.
Syntax
isdp holdtime time
no isdp holdtime
• time —The time in seconds (range 10–255 seconds).
Default Configuration
The default holdtime is 180 seconds.
Command Mode
Global Configuration mode