Dell PowerConnect 6224 - Deadtime

502 RADIUS Commands
Example
The following example sets the port number 2412 for authentication
requests.
console(config)#radius-server host 192.143.120.123
console(config-radius)#auth-port 2412
deadtime
Use the deadtime command in Radius mode to improve Radius response
times when a server is unavailable by causing the unavailable server to be
skipped.
Syntax
deadtime deadtime
• deadtime — The amount of time that the unavailable server is skipped
over. (Range: 0-2000 minutes)
Default Configuration
The default deadtime interval is 0 minutes.
Command Mode
Radius mode
User Guidelines
User must enter the mode corresponding to a specific Radius server before
executing this command.
Example
The following example specifies a deadtime interval of 60 minutes.
console(config)#radius-server host 192.143.120.123
console(config-radius)#deadtime 60