Captive Portal Commands 1085
user session-timeout
Use the user session-timeout command to set the session timeout value for a
captive portal user. Use the “no” form of this command to reset the session
timeout to the default.
Syntax
user
user-id
session-timeout
timeout
no user
user-id
session-timeout
•
user-id
—User ID (Range: 1–128).
•
timeout
—Session timeout. 0 indicates use global configuration (Range:
0–86400 seconds).
Default Configuration
The global session timeout is used by default.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP)#user 1 session-timeout 86400
console(config-CP)#no user 1 session-timeout
Captive Portal Status Commands
show captive-portal configuration
Use the show captive-portal configuration command to display the
operational status of each captive portal configuration.
To Next Page
Loading...
