OSPF Commands 909
Type Router Id Cost Area ID Next Hop Next
Hop
Intf
----- ---------- ---- -------- ----------- -----
------
INTRA 1.1.1.1 1 0.0.0.1 10.1.12.1 vlan1
0
INTRA 4.4.4.4 10 0.0.0.1 10.1.24.4 vlan1
2
show ip ospf database
Use the show ip ospf database command in Privileged EXEC mode to display
information about the link state database when OSPF is enabled. If
parameters are entered, the command displays the LSA headers. Use the
optional parameters to specify the type of link state advertisements to display.
Syntax
show ip ospf [
<area-id>
] database [{asbr-summary | external | network |
nssa-external | router | summary}][
ls-id
] [adv-router [
ip-address
] | self-
originate]
•
area-id
— Identifies a specific OSPF area
for which link state database
information will be displayed.
• asbr-summary — Display the autonomous system boundary router (ASBR)
summary LSAs.
• external — Display the external LSAs.
• network — Display the network LSAs.
• nssa-external — Display NSSA external LSAs.
• router — Display router LSAs.
• summary — Display the LSA database summary information.
• ls-id — Specifies the link state ID (LSID). (Range: IP address or an integer
in the range of 0–4294967295)
To Next Page
Loading...
