Dell PowerConnect 6224 - Show Logging File

1288 Syslog Commands
11-Aug-2005 15:41:43: %LINK-3-UPDOWN: Interface Ethernet
g1, changed state to up
11-Aug-2005 15:41:43: %LINK-3-UPDOWN: Interface Ethernet
g1, changed state to up
11-Aug-2005 15:41:43: %LINK-3-UPDOWN: Interface Ethernet
g2, changed state to up
11-Aug-2005 15:41:43: %LINK-3-UPDOWN: Interface Ethernet
g3, changed state to up
11-Aug-2005 15:41:43: %SYS-5-CONFIG_I: Configured from
memory by console
11-Aug-2005 15:41:39: %LINEPROTO-5-UPDOWN: Line protocol on
Interface FastEthernet g1, changed state to up
11-Aug-2005 15:41:39: %LINEPROTO-5-UPDOWN: Line protocol on
Interface Ethernet g1, changed state to down
11-Aug-2005 15:41:39: %LINEPROTO-5-UPDOWN: Line protocol on
Interface Ethernet g1, changed state to down
11-Aug-2005 15:41:39: %LINEPROTO-5-UPDOWN: Line protocol on
Interface Ethernet g2, changed state to down
11-Aug-2005 15:41:39: %LINEPROTO-5-UPDOWN: Line protocol on
Interface Ethernet 1/3, changed state to down
show logging file
Use the show logging file command in Privileged EXEC mode to display the
state of logging and the syslog messages stored in the logging file.
Syntax
show logging file
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode