Dell PowerConnect 6224 - Show Captive-Portal Configuration Client Status

1076 Captive Portal Commands
CP Name................................... cp1
Interface................................. 1/g1
Interface Description..................... Unit: 1 Slot: 0
Port: 1 Gigabit - Level
User Name................................. user123
Session Time.............................. 0d:00:00:13
show captive-portal configuration client status
Use the show captive-portal configuration client status command to display
the clients authenticated to all captive portal configurations or a to specific
configuration.
Syntax
show captive-portal configuration [ cp-id ] client status
• cp-id —Captive Portal ID.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
console#show captive-portal configuration client status
CP ID CP Name Client MAC Address Client IP Address
Interface
----- --------------- ------------------ -----------------
---------
1 cp1 0002.BC00.1290 10.254.96.47
1/g1