Dell PowerConnect 6224 - Ipv6 Pimsm Spt-Threshold

IPv6 Multicast Commands 757
• prefixlength—This parameter specifies the prefix length of the IP address
for the media gateway. (Range: 1–32)
Default Configuration
The router does not advertise itself as a PIM candidate rendezvous point by
default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm rp-candidate vlan 6
ff1e::/64
ipv6 pimsm spt-threshold
Use the ipv6 pimsm spt-threshold command to configure the Data
Threshold rate for the last-hop router to switch to the shortest path. Use the
"no" form of this command to set the data threshold to the default.
Syntax
ipv6 pimsm spt-threshold threshold
no ipv6 pimsm spt-threshold
• threshold —The threshold rate (Range: 0–2000 Kbps).
Default Configuration
The default threshold rate is 0.
Command Mode
Global Configuration mode