Dell PowerConnect 6224 - Ipv6 Pimsm Rp-Candidate

756 IPv6 Multicast Commands
Syntax
ipv6 pimsm rp-address rp-address group-address/prefixlength [ override ]
no ipv6 pimsm rp-address
• rp-address —An RP address.
•
group-address —The group address to display.
•
prefixlength —This parameter specifies the prefix length of the IP address
for the media gateway. (Range: 1–32)
Default Configuration
There are no static RP addresses configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm rp-address 2001::1
ff1e::/64
ipv6 pimsm rp-candidate
Use the ipv6 pimsm rp-candidate command to configure the router to
advertise itself as a PIM candidate rendezvous point (RP) to the bootstrap
router (BSR). Use the "no" form of this command to disable the router from
advertising itself as a PIM candidate rendezvous point (RP) to the bootstrap
router (BSR).
Syntax
ipv6 pimsm rp-candidate vlan vlan-id group-address/prefixlength
no ipv6 pimsm rp-candidate vlan vlan-id
• vlan-id—A valid VLAN ID value.
• group-address—The group address to display.