308 Ethernet Configuration Commands
show statistics ethernet
Use the show statistics ethernet command in Privileged EXEC mode to
display detailed statistics for a specific port or for the entire switch.
Syntax
show statistics ethernet { <
unit
>/<
port-type
><
port
> | switchport }
•
unit
— Physical switch identifier within the stack. Values are
1-12
.
•
port-type
— Values are
g
for gigabit Ethernet port, or
xg
for 10 gigabit
Ethernet port.
•
port
— port number. Values are
1-24
or
1-48
for port_type g, and 1-4 for
port_type xg.
Example: xg2 is the 10 gigabit Ethernet port 2.
•
switchport
— Displays statistics for the entire switch.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Type The port designated IEEE shorthand identifier. For example
1000Base-T refers to 1000 Mbps baseband signaling including both
Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
Link State Displays the Link Aggregation status.
To Next Page
Loading...
