Dell PowerConnect 6224 - Show Classofservice Ip-Dscp-Mapping

QoS Commands 483
User Priority Traffic Class
------------- ---------------
01
11
26
34
43
54
65
76
The following table lists the parameters in the example and gives a
description of each.
show classofservice ip-dscp-mapping
Use the show classofservice ip-dscp-mapping command in Privileged EXEC
mode to display the current IP DSCP mapping to internal traffic classes for a
specific interface.
Syntax
show classofservice ip-dscp-mapping
• Command is supported only globally.
Default Configuration
This command has no default configuration.
Parameter Description
User Priority The 802.1p user priority value.
Traffic Class The traffic class internal queue identifier to which
the user priority value is mapped.