482 QoS Commands
show classofservice dot1p-mapping
Use the show classofservice dot1p-mapping command in Privileged EXEC
mode to display the current Dot1p (802.1p) priority mapping to internal
traffic classes for a specific interface.
Syntax
show classofservice dot1p-mapping [<
|port-
channel
port-channel number
]
•
— Specifies a valid unit/port combination:
–<
unit
> — Physical switch identifier within the stack. Values are
1-12
.
–<
port-type
> — Values are
g
for gigabit Ethernet port, or
xg
for 10
gigabit Ethernet port.
–<
port
> — port number. Values are
1-24
or
1-48
for port_type g, and
1-4 for port_type xg.
Example: xg2 is the 10 gigabit Ethernet port 2.
•
port-channel number
— Specifies a valid port-channel number. Range is 1-
8.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
If the interface is specified, the 802.1p mapping table of the interface is
displayed. If omitted, the most recent global configuration settings are
displayed.
Example
The following example displays the dot1p traffic class mapping and user
priorities.
console#show classofservice dot1p-mapping
To Next Page
Loading...
