802.1x Commands 633
show dot1x clients
Use the show dot1x clients command in Privileged EXEC mode to display
detailed information about the users who have successfully authenticated on
the system or on a specified port.
Syntax
show dot1x clients {all |ethernet
interface
}
•
all
— All 802.1X clients authenticated on the system
•
interface
— A valid Ethernet interface.
Supplicant Timeout The timer used by the authenticator state machine on this
port to timeout the supplicant. The value is expressed in
seconds and will be in the range of 1 and 65535.
Server timeout Time in seconds the switch waits for a response from the
authentication server before resending the request.
Authenticator PAE State Current state of the authenticator PAE state machine.
Possible values are Initialize, Disconnected, Connecting,
Authenticating, Authenticated, Aborting, Held,
ForceAuthorized, and ForceUnauthorized.
Backend Authentication
State
Current state of the backend authentication state
machine. Possible values are Request, Response, Success,
Fail, Timeout, Idle, and Initialize.
Authentication success Counts the number of times the state machine has
received a Success message from the Authentication
Server.
Authentication fails Counts the number of times the state machine has
received a Failure message from the Authentication Server.
Supplicant MAC Address The MAC-address of the supplicant
Filter-ID The Filter Id assigned to the client by the RADIUS server.
This field is not applicable when the Filter-Id feature is
disabled on the RADIUS server and client.
Field Description
To Next Page
Loading...
