Dell PowerConnect 6224 - Name

1070 Captive Portal Commands
• web-id —The locale number (Range: Only locale 1 is supported)
Default Configuration
Locale 1 is configured by default.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
name
Use the name command to configure the name for a captive portal
configuration. Use the “no” form of this command to remove a configuration
name.
Syntax
name cp-name
no name
• cp-name —CP configuration name (Range: 1–32 characters).
Default Configuration
Configuration 1 has the name “Default” by default. All other configurations
have no name by default.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#name cp2