Dell PowerConnect 6224 - Ipv6 Pimsm Dr-Priority; Ipv6 Pimsm Hello-Interval

IPv6 Multicast Commands 753
ipv6 pimsm dr-priority
Use the ipv6 pimsm dr-priority command to set the priority value for which a
router is elected as the designated router (DR). Use the "no" form of this
command to set the priority to the default.
Syntax
ipv6 pimsm dr-priority priority
no ipv6 pimsm dr-priority
• priority —The election priority (Range: 0–2147483647).
Default Configuration
The default election priority is 1.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 pimsm dr-priority 10
ipv6 pimsm hello-interval
Use the ipv6 pimsm hello-interval command to configure the PIM-SM Hello
Interval for the specified interface. Use the "no" form of this command to set
the hello interval to the default.
Syntax
ipv6 pimsm hello-interval interval
no ipv6 pimsm hello-interval
• interval—The hello interval (Range: 0–65535 seconds).