Dell PowerConnect 6224 - Hostname; Initiate Failover

System Management Commands 1297
Example
console(config)#cut-through mode
The mode (enable) is effective from the next reload of
Switch/Stack.
hostname
Use the hostname command in Global Configuration mode to specify or
modify the switch host name. To restore the default host name, use the no
form of the command.
Syntax
hostname name
no hostname
• name — The name of the host. (Range: 1–255 characters)
Default Configuration
Host name not configured.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies the switch host name.
console(config)# hostname Dell
initiate failover
To manually force a failover from the management unit to the backup unit in
a stack, use the initiate failover command in Stack Configuration mode.