132 Command Groups
Telnet Server
User Interface
switch renumber Changes the identifier for a switch in the stack. GC
telnet Logs into a host that supports Telnet. PE
traceroute Discovers the IP routes that packets actually
take when travelling to their destinations.
PE
NOTE: *For the meaning of each Mode abbreviation, see "Mode Types" on page 60.
Command Description Mode*
ip telnet server disable Enables/disables the Telnet service on the
switch.
GC
ip telnet port Configures the Telnet service port number on
the switch.
GC
show ip telnet Displays the status of the Telnet server and the
Telnet service port number.
PE
NOTE: *For the meaning of each Mode abbreviation, see "Mode Types" on page 60.
Command Description Mode*
enable Enters the privileged EXEC mode. UE
end Gets the CLI user control back to the privileged
execution mode or user execution mode.
Any
exit(configuration) Exits any configuration mode to the previously
highest mode in the CLI mode hierarchy.
(All)
exit(EXEC) Closes an active terminal session by logging off
the switch.
UE
mode simple Selects the simple mode as the start up mode. GC
mode-change confirm Confirms the mode selection. GC
NOTE: *For the meaning of each Mode abbreviation, see "Mode Types" on page 60.
Command Description Mode*
To Next Page
Loading...
