Dell PowerConnect 6224 - Page 131

Command Groups 131
show memory cpu Checks the total and available RAM space on
the switch.
PE
show nsf Shows non-stop forwarding status. PE
show process cpu Checks the CPU utilization for each process
currently running on the switch.
PE
show sessions Displays a list of the open telnet sessions to
remote hosts.
PE
show stack-port Displays summary stack-port information for all
interfaces.
PE
show stack-port
counters
Displays summary data counter information for
all interfaces.
PE
show stack-port diag Displays front panel stacking diagnostics for
each port.
PE
show stack-standby Shows the Standby configured in the stack. UE
show supported
switchtype
Displays information about all supported switch
types.
UE
show switch Displays information about the switch status. UE
show system Displays system information. UE
show system id Displays the service ID information. UE
show tech-support Displays system and configuration information
(for debugging/calls to technical support).
PE
show users Displays information about the active users. PE
show version Displays the system version information. UE
stack Sets the mode to Stack Global Configuration
mode.
GC
stack-port Sets the mode to Stack Global Configuration
mode to configure Stack ports as either
Stacking ports or as Ethernet ports.
GC
standby Configures the standby in the stack. SG
switch priority Configures the ability of the switch to become
the Management Switch.
GC
Command Description Mode*