Dell PowerConnect 6224 - Area Virtual-Link Retransmit-Interval

OSPFv3 Commands 945
User Guidelines
This command has no user guidelines.
Example
The following example configures a hello interval of 20 seconds for the OSPF
virtual interface on the virtual interface identified by area 1
and its neighbor.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2 hello-
interval 20
area virtual-link retransmit-interval
Use the area virtual-link retransmit-interval command in Router OSPFv3
Configuration mode to configure the retransmit interval for the OSPF virtual
interface on the virtual interface identified by
areaid and neighbor .
Syntax
area areaid virtual-link neighbor retransmit-interval seconds
no area areaid virtual-link neighbor retransmit-interval
• areaid — Valid OSPFv3 area identifier.
•
neighbor — Router ID of neighbor.
•
seconds — Retransmit interval. (Range: 0-3600)
Default Configuration
5 is the default value for seconds .
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.