Dell PowerConnect 6224 - Ipv6 Unreachables; Show Dos-Control

1140 Denial of Service Commands
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 icmp error-interval 2000 20
ipv6 unreachables
Use the ipv6 unreachables command to enable the generation of ICMPv6
Destination Unreachable messages. Use the “no” form of this command to
prevent the generation of ICMPv6 Destination Unreachable messages.
Syntax
ipv6 unreachables
no ipv6 unreachables
Default Configuration
ICMPv6 Destination Unreachable messages are enabled by default.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan10)#ipv6 unreachables
show dos-control
Use the show dos-control command in Privileged EXEC mode to display
Denial of Service configuration information.