Dell PowerConnect 6224 - Show Switchport Voice

562 Switchport Voice Commands
show switchport voice
Use the show switchport voice command to show the status of auto-voip on
an interface or all interfaces.
Syntax
show switchport voice [interface {ethernet interface | port-channel index }]
• ethernet interface —Specifies a valid interface. The full syntax is unit/port.
•
port-channel index — Specifies the port-channel number.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
console#show switchport voice
Interface Auto VoIP Mode Traffic Class
--------- -------------- -------------
1/g1 Enabled 6
1/g2 Enabled 6
1/g3 Enabled 6
1/g4 Enabled 6
1/g5 Enabled 6
1/g6 Enabled 6
1/g7 Enabled 6