IPv6 Routing Commands 771
Example
The following example globally enables IPv6 forwarding.
console#configure
console(config)#ipv6 forwarding
console(config)#no ipv6 forwarding
ipv6 host
The ipv6 host command is used to define static host name-to- ipv6 address
mapping in the host cache.
Syntax
ipv6 host
name
ipv6-address
no ipv6 host
name
•
name
— Host name.
•
ipv6-address
— IPv6 address of the host.
Default Configuration
No IPv6 hosts are defined.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config)#ipv6 host Dell 2001:DB8::/32
To Next Page
Loading...
