Dell PowerConnect 6224 - Ipv6 Ospf Transmit-Delay

OSPFv3 Commands 959
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF retransmit interval at 100 seconds.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf retransmit-
interval 100
ipv6 ospf transmit-delay
Use the ipv6 ospf transmit-delay command in Interface Configuration mode
to set the OSPF Transmit Delay for the specified interface.
Syntax
ipv6 ospf transmit-delay seconds
no ipv6 ospf transmit-delay
• seconds — OSPF transmit delay for the specified interface. In addition, it
sets the estimated number of seconds it takes to transmit a link state
update packet over this interface. (Range: 1 to 3600 seconds)
Default Configuration
No default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF Transmit Delay at 100 seconds for
VLAN 15.
console(config)#interface vlan 15